DIY- Ring Holder

It is simple to make
All you need is a
wooden dowel- depends on the thickness you want
a piece of wood- doesn't really matter what kind
hand saw
drill with bit
spray paint

All you do 
Cut your dowels to any length you want. Then decide on the size you want your piece of wood to be, I left enough room in between them, so I can take them off easier.
Then you want to see where you want your dowels to go, I went in a inch on either side, drill your hole but don't go all the way through. Then just push them in if you want use your hammer and tap them in.
Sand the edges of the wood and spray paint.
It will look somewhat like this.

Now my rings wont be lying around. My next task is a earring holder.